Follow me
-
Categories
-
Recent posts
Recent comments
- EMC World - Day 4 - VNX: Skew & Data Placement | FastStorage on EMCWorld 2013: Without skew, no flash
- Menno de Liège on Bulk add zones on Brocade FOS using Powershell
- Menno de Liège on EMCWorld 2013: IOPS calculation for your FAST Pool
- dynamox on EMCWorld 2013: IOPS calculation for your FAST Pool
- Rob Koper on EMCWorld 2013: IOPS calculation for your FAST Pool
Links
Tag Archives: bond1
Avamar 6.0.1-65 Bug in adding nodes
This week I was adding Avamar 7.8TB nodes to existing Avamar Data Store Gen 4 Grids and I discovered a bug in adding and starting the new nodes. After adding and starting the nodes, the clients were redirected to the … Continue reading
Posted in Avamar
Tagged --addr=, --allow=backup, --clean, --type=storage, 1, 192.168.255, 192.168.255.0, 3, 4, 6, 6.0.1-65, 7.8, 7.8tb, add, ads3, ads4, avamar, avmaint, avtar, balancemin, balancemin=0, balancemin=2, bond, bond0, bond1, bonding, bug, checkpoint, client, clients, config, data, error, eth0, eth1, eth2, eth3, fatal, gen3, gen4, grid, grids, gsan, hfs, hfscheck, if, info, internal, LAN, networkconfig, node, nodedb, nodes, pack, probe, probe.xml, procedure, Service, sp1, start.nodes, Storage, store, Switch, switches, tb, utility, vlan, xml
Leave a comment
Avamar trunking: Avamar on a stick
A nice feature of the Avamar Datastore Generation 4, is that you can use trunks to connect multiple VLAN’s to the same Avamar backup port. When installing a fresh Avamar, you will do this using dpnnetutil, but when you need … Continue reading
Posted in Avamar
Tagged -s, 1, 2, 3, 4, 5, 6, active, ADS, avamar, backup, balancing, bond, bond0, bond1, bonding, channel, data, dpnnetutil, drac, eth, eth0, eth1, eth2, eth3, failover, gen, gen4, grid, idrac, ifcfg-bond0, ifcfg-bond1, ifcfg-eth0, ifcfg-eth1, interface, LAN, load, master, network, NIC, onboot, passive, Port, racadm, recovery, reduncancy, routing, setniccfg, slave, stick, store, sub, subinterface, sysconfig, team, teaming, vlan
1 Comment